The pressure at the bottom of a 3-meter deep swimming pool is 29,400 pa.

## How do I calculate the pressure at the bottom of my pool?

Let us calculate the pressure exerted on the bottom by the weight of the fluid. That pressure is the weight of the fluid mg divided by the area A supporting it (the area of the bottom of the container): P=mgA P = m g A .

## What is the total force on the bottom of a swimming pool?

The total force on the pool bottom is then equal to: F = 1.23*10^5 N/m^2 * 80 m^2 = 98.4*10^5 N, i.e about 984 tonnes. The weight of the water in the pool is about 184 tonnes. Richard Alsenz, inventing and physics are my passion. The pressure is independent of the area of the pool.

## What is the pressure of 1 meter of water?

Depth and hydrostatic pressure

Height of Water Column | Pressure | |
---|---|---|

(m) | (ft) | (kPa) |

1 | 3.28 | 9.81 |

2 | 6.56 | 19.6 |

3 | 9.84 | 29.4 |

## How do you calculate pressure below sea level?

So if you’re right at sea level, the pressure will be 14.7 psi. And for every foot you go underwater, you add another 0.445 psi. So at one foot deep, the pressure would be 14.7 psi + 0.445 psi = 15.145 psi. And at two feet deep it would be 14.7 psi + 2*(0.445 psi) = 15.59 psi, etc.

## How do I calculate pressure?

Find the area of that surface. Make sure that both values are in the correct units, i.e., newtons/meters squared or pounds/inches squared. Divide force by the area. Your pressure will be expressed in pascals (Pa) or pounds per square inch (psi).

## Why does water pressure increase with depth?

Pressure increases as the depth increases. The pressure in a liquid is due to the weight of the column of water above. Since the particles in a liquid are tightly packed, this pressure acts in all directions. … The greater pressure at the bottom would give a greater ‘force per unit area’ on the wall.

## How do you calculate total force?

We can figure out the total force by subtracting one force from the other. For example, if a block is being pushed with a force of 7 newtons left and 4 newtons right, the total force on the block is 3 newtons left.

## How do you convert pressure to level?

The pressure reading is directly proportional to the weight of diesel above the sensor, so the level is calculated by first multiplying the density and acceleration due to gravity together, and then dividing the result into the pressure reading.

## How do I calculate static pressure?

There are two different ways to measure static pressure. The first (and most common) measure is to take the force exerted by the fluid and divide it by the area over which it is acting.

## How do you calculate water head pressure?

Divide the depth in inches by 27.71-inches/psi, or the depth in feet by 2.31-feet/psi which are the English unit conversion factors. The result is the water head pressure expressed in psi.

## At what depth will water crush you?

At about 10–12 meters (33–40 feet) of depth, pressure of water column above you (1 extra atmosphere of pressure per 10 meters) will compress air spaces in your body by half, with lungs compressing the most by the absolute volume.

## Does pressure increase with height?

As altitude rises, air pressure drops. In other words, if the indicated altitude is high, the air pressure is low. This happens for two reasons. … As altitude increases, the amount of gas molecules in the air decreases—the air becomes less dense than air nearer to sea level.

## Does water pressure increase with height?

Water pressure decreases with height.